![]() The STACKS statement has a range of 8-64, 32-512. In special circumstances, this line was changed to STACKS=9,128. ![]() Later in MS-DOS 3.3 the line STACKS=0,0 was added into the config.sys. STACKS=0,0 The stacks line was first used in MS-DOS 3.2 and was used to swap the stack whenever an asynchronous hardware interrupt occurred. Also, make sure that this line is all as one line and that there is not a space between and after the =. However, going higher may decrease the computer’s performance ģ0 is found to work the best. FILES=30 The files line allow Windows to load 30 files at the same time. Some older MS-DOS games have problems with extended memory and will not run without the NOEMS statement. DEVICE=C:\Windows\EMM386.EXE NOEMS The EMM386 line loads the extended memory manager. Note the location usually best placed after the DOS=HIGH,UMB Load DOS into high memory in an upper memory block. If this line is not present, Windows 3.x will not load. #Best dos editor driversCommand Explanation DEVICE=C:\Windows\HIMEM.SYS The Himem.sys line is an important line this line allows you to load drivers into high memory. The next table will explain, line by line, every command on the Config.sys file. Here is an example of the content of a typical config.sys file: DEVICE=C:\Windows\HIMEM.SYS The config.sys file is editable in MS-DOS Editor or any other text editor available. ![]() Windows 95 and Windows 98 also include a config.sys file, but it is present only for backward compatibility with 16-bit Windows applications running under Windows 95 or Windows 98. Lastdrive specifies the highest available drive letter.ĭos allows you to load MS-DOS into the high memory area and to give programs access to the upper memory area.Īfter the config.sys file’s commands are executed, the autoexec.bat file is executed. #Best dos editor driverDevice commands are used to load device drivers for different hardware, such as the extended memory driver himem.sys. A typical config.sys file includes commands such as device, lastdrive, and dos.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |